Need a PCB design expert

Using PIC18F4580, I want to write a program that do the following : - When the switch is on there is an output LED 1 Light that represents the device is started ( run) ,like any simple device. - Mainly the device check continuously if another switch (special switch) is triggered ,DC buzzer and LED 2 light is running as alarm - Lastly, there is PUSH BOTTON 2 that switched on to senses any motion using motion sensor PIR. After that, the device outputs the same DC buzzer and LED 2 Light as alarm, and will be switched OFF if the user pressed PUSH BOTTON 2, so the user make sure the device doesn’t detect him as false detection Note that: 1- This device is Electronic Fishing Bite & Security Alarm, just to clarify this project requirements 2- I want to use C language using Mplab , and I need use Proteus to simulate the device circuit.