I need someone who can help me or is capable to teach me to build and code simple "Scale project"
Scale project is made of
- Scales (one to several units)
- Scale controller (one unit)
Scale is made of:
- load cell
It give read on request by scale controller.
Scale controller is made of
- UNO (chines arduino)
- Power source (also powering Scale)
- GSM module (for later GPRS communication to the database server).
- storage for init files if need (optional), to avoid reprogramming for adding/removing scales
Scale controller master Scales and demand data from them i.e. every 30 sec.
It is very important that this work in power safe mode while will run on battery.
I have seven years experience in Arduino hardware and software design if you assign to me I can deliver it with good quality and within the time.
19 freelance font une offre moyenne de €213 pour ce travail
I work with "bare" Atmeba MCUs and Arduino boards and have both Arduino and Atmega16 and all other components here. I work with Atmega chips since 2010 and have more than 20 years of experience in electronics and p Plus
Dear Sir I am an Electrical Engineer and I have built the similar device before. Since I have the experience so I can teach you better. Discuss the details with me. Looking forward to have a long term relationship. Plus
Hello Sir, i have already so many projects regarding loadcell with HX710 and HX711 for weigh bridges so it will be more interested to me to do your project. Thanks Manthan.
Hello I'm a controls engineer with tons of industrial automation and Arduino experience. Please contact me to discuss the project Best regards, Dennis
I am new on Freelancer.com but I have more than 10-years of experience on Embedded Systems, Embedded Linux, I have developed dozens of board with SoCs from several manufacturers (NXP, Broadcom, ST, Texas Instruments, A Plus
Mon connaissance naturelle en électrique depuis mes enfance après en programmation informatique et enfin mes connaissance obtenu au sein de bureau d'etude. j'observe que avec mes compétence je peut resoudre n'importe q Plus
hello i have implemented a similar project with arduino ,we can burn arduino firmware on atmega 16 to achieve ur target proj
Hi i have done same project here on freelancer it was BMI calculator using Arduino+ HX711+ Ultrasonic sensor. You can verify that in my review section. I have exeperiance of interfacing SD card and GSM with ardui Plus
Hola, Soy ingeniero en Electrónica con postgrado en Telecomunicaciones, que es mi actividad comercial principal, además estoy dedicado a la Docencia Universitaria desde hace 25 años, ahora dicto las cátedras de Lógic Plus