I'm looking to make a candy mold for my class.
I want the mold to be able to make 96 identical candies. Each candy will be imprinted on both sides with the name NicZ running in opposite directions. The words should run across the entire top centered. Using the font in the Emerald Cut picture if possible (AR JULIAN). The words should be indented 1 millimeter and sized to fit the top portion of the candy when centered.
The shape should be of an Emerald Cut. See Image emerald cut for reference.
Since this is going to be a mold for making candy I'd like each candy to be connected by a 2 millimeter diameter 2 millimeter long tunnel to the next candy in the row. Each row should consist of 10 candies. At the end of each row connect a tunnel to the next row. IN the four corners I want 7mm hole.
The spacing between each candy should be 2mm all the way around. Each candy should be 13mm long and 6.5 mm thick. Since this is a mold for a candy it will have to have two identical plates to form the candy. So the recess for candy in each half mold will be 3mm. The entire plate will be 5 mm thick since I want 2mm excess material all around the candy. See mold image.
In the top plate there will be a 4mm diameter hole in both the 1st and last candy. To allow me to inject liquid candy.
Lastly I want a sleeve that is extends 5mm high by 2mm thick of the outside of the base plate so i can slip the top plate onto the bottom plate and make a seal.
Hopefully this doesn't cost to much since it's really one thing repeated multiple times.
1 freelance fait une offre moyenne de $111 pour ce travail
hi sir lets begin the work as possible as soon i'm ready to begin and thanks for trust me for doing this job i will do my best work to make you are satisfied thanks sir