Slide & Buttons
Budget $8 USD / heure
Hello, I am attaching a file of a project that someone else started. However, it is only about 80% complete. The project consists of a "SLIDE" and 2 "BUTTONS". The buttons are exact in every way, except height. One will be 7.5 mm and the other will be 1 cm. These buttons need a way to sit flush on the slide and snap on. In addition, the slide needs a sexier shape. The function and the dimensions are fine, but it needs to have a slight "S" shape to make it look more fun and playful.
Also note that the SLIDE and BUTTONS will be injection molded, but in different plastics. The slide will be in polypropylene and the buttons in a synthetic rubber so this needs to be taken into consideration for design.
I would like the buttons to maintain at least a 3mm thickness.
You may notice that the slide curves up slightly. That is necessary, but the buttons also need to follow this contour. You will also notice that the buttons are placed off-center. That too is necessary. Please advise. Thank you. Denise