Build program to auto perform sequence of inputs & actions

I require a program to be built that when activated will perform a series of tasks/actions on another (windows-based) software program which I have.

There are two input fields in this software which I want the program to address.

Field 1: drop-down menu containing around 60 different options.

Field 2: (is on a different tab on the software user interface) a field in which you type a number from 0 to 359 (these are degrees).

I would like the program to be built to perform the following sequence of events:

1. Select drop-down menu option 1 from field 1

2. Enter '0' into field 2

3. Click the 'calculate' button. The software performs a series of calculations (takes anywhere from 10 seconds to 2 minutes) and produces a results report on another tab. On the report a number from 0.0 to 10.0 is calculated and shown.

4. Record the number from 0.0 to 10.0 that has been generated into an excel spreadsheet or similar, along with the 2 input fields that were used in that calculation.

Then repeat these steps in the following way:

a) change input field 2 to '45', then push 'calculate', record results

change input field 2 to '90', then push 'calculate', record results

change input field 2 to '135', then push 'calculate', record results

change input field 2 to '180', then push 'calculate', record results

change input field 2 to '225', then push 'calculate', record results

change input field 2 to '270', then push 'calculate', record results

change input field 2 to '315', then push 'calculate', record results

b) once this sequence has completed, then change input field 1 to drop-down option 2 and start over. and so on until for each of the 60 drop down options in field 1, 8 seperate calculations have been made using the 8 diffent inputs for field 2 - and each time the resulting 0.0-10.0 number has been recorded along with its corresponding field inputs.

Ideally I would like to be able to select which of the 1-60 options in field 1 (drop down menu) will be used in the sequence. Sometimes I want the 8 calculations performed for all 60 field 1 options, but other times I want to select just a few field 1 options to be apart of the sequence.

Once set up I want this program to run automatically so that after a few hours or however long it takes to run through the sequence I have a report with the generated number from each calculation along with its individual corresponding field inputs.

Upon acceptance of the job I will send you the software program (around 5mb) so you can see and understand it.

Payment will be provided upon successful completion of the task.

PHP Architecture Logicielle

Nº du projet : #1084433

À propos du projet