I am wanting to have 2 separate RGB cameras that can record to a Micro SD-Card or if it will be easier to have each of them recording to separate Micro-SD Cards that will be fine. I am not 100% sure what else will be needed for this project. I am assuming a PCB board, Micro-Controllers etc. If it is possible to get a quote for all each camera using all three RGB connectors and a quote for just the yellow RGB connector that would be great! If the project is going to be over the $30 to $250 range we can set up goals to be accomplished and move forward from there.
7 freelances font une offre moyenne de 412 $ pour ce travail
Hello, thank you for your job posting. I read your description about--2 RGB cameras record directly to Micro SD-Card I am a senior electrical engineer. I have plenty of experience in firmware development and micro-con Plus
Best PCB Design Expert at your doorstep! Dear Client, We can do 2 separate RGB cameras that can record to a Micro SD-Card. We couldn’t stop ourselves from bidding after going through the description as they are an exa Plus
Hello, Dear. I am an electronic engineer and PCB designer. I am also automatic control expert. I have experience of designing video streaming module with STM32 in Drone. The task of module was to compress time serial R Plus
Hello, I have checked your project description ..... I have good knowledge and experience in this field. I could do this job best and give you an outstanding result as you expect. I’m glad to answer any questions you Plus
Hello, I am Sachin from Bangalore work on Embedded Systems, PCB design, Schematics, layout design, fabrication service, components assembling, testing, PCB board services, etc. I work for development of POC, prototypes Plus