En cours

remote control knob (wired)

Hello:

I have a TIG welder that is low-end. It has current control only on the power source with no option to connect a remote control (pedal or torch knob) like higher end models do.

I am interested in having a small wired remote control knob that can attach to the torch handle and would allow me to adjust the current up or down back at the power source.

I am mechanically inclined but am a novice at reading electrical diagrams. Project would entail blue print and instructions. All parts should be easily acquired (standard).

Edit 1: The knob must have some resistance on it to prevent accidental current change during torch usage. A very smooth easy to move knob would not be good. Perhaps indexed.

Compétences : Electronique

Voir plus : power up reading, novice novice, i control, remote power, print models, pedal, control, electrical small project, small electrical project, power control, knob, remote control source, electronics small project, source control, project electrical, electrical power control, wired remote knob, knob control flash, remote project, novice, control remote pc, BLUE PRINT, skype control remote, ajax knob control, wired ipod control

Concernant l'employeur :
( 0 commentaires ) Seattle, United States

N° du projet : #1020080

3 freelance ont fait une offre moyenne de 133 $ pour ce travail

IoliteTech

Hi, Please Check PM.

50 $ USD en 5 jours
(2 Commentaires)
1.7
bkalaska

I can do this. I was the supervisor for the welding shop at Incat Catemerans in Tasmania, Australia. Have done this kind of thing a lot of times. Will need make and model of your welder. I will supply wired potentiomet Plus

100 $ USD en 7 jours
(0 Commentaires)
0.0
rbettes

I have extensive experiance in designing spot weld controllers/timers which can work in standard mode or constant current. Regards Roy

250 $ USD en 30 jours
(0 Commentaires)
0.0