Looking for Firmware engineer experienced in STM32F407 development.
- Should have experienced in CAN protocol and SPI.
- Looking to work from Pune, India. Not mandatory though.
- Details about the requirement will be shared with the suitable candidate.
- Open position for Full time employee or part time developer.
14 freelances font une offre moyenne de 67107 ₹ pour ce travail
Hi there, I have almost 13 years of experience. I have read the details and have a few questions. Please get back to me to discuss it further. Waiting for your reponse Thanks.
Hi, I hope you are doing fine. I am an expert in C programming, Microcontroller (AVR, ARM and etc), Arduino and Python.I have done some simulation and testing various type of Microcontrollers and sensors. I have exper Plus
Are you looking for someone who has very experienced in stm32F407 firmware development? Especially CAN? if Yes, please contact me. I have rich experience in Stm32 and CAN, I built a project using stm32. In the project Plus
I have more than 7 years experience in embedded hardware and firmware development . So I can do your job within a time limit with your satisfaction.
• GPRS(etc) I am specialist in development and interfacing between Android application and arduino board. hardware designing for embedded hardware. software development for embedded hardware. Home automation. Plus
Hello, I am a Senior Software developer. I have been working as a embedded firmware and hardware designer for 10+ years. I had developed several similar projects using the various microcontrollers such as STM32F1/2/3/4 Plus
Hi, I have expertise in STM32 and embedded systems, CAN,SPI etc. Refer my profile for details. Please send me detailed requirements. Thanks.
Hello, I have 10+ years of Embedded product design with multiple domains like a consumer, industrial, automotive, IOT and wearable product. -Hardware architecture design using MCU, controller, and FPGA, as well as low Plus
Hai sir I read your project details I can support your project end to end feel free to contact me I give a support
I designed firmware and hardware of an OBD device with STM32407 and Siliconlabs' chip BGM121. I think my experince with the OBD project fullfills the requirments of your project and shortenst the project development ti Plus
TSD Techno Services worked on electronics and embedded products and services. Hardware design and development. Firmware design and development. Software design and development. Prototype development. IoT design a Plus
Hello, I am electronics engineering graduate from mumbai university. I have also done embedded system course. I have worked on few embedded projects. I have experience with different microcontrollers and can program in Plus