Adapt PCB from Eagle to KiCAD and increase performance from current 80A to 200A with peaks of 400A (specify heatsink for the design).
Theoretically, used MOSFETs (FDMT80080DC, two in parallel) should be capable to handle 200A requested currents if they are cooled properly, but heatsink must be calculated. Also the Würth press-fit elements are already capable to handle 200A in theory.
Probably it would be more safe to redesign the board for more MOSFETs in parallel. In addition to that, the board should be produced with thicker copper plating, currently only done 70µm.
Hello there, I have read your project description and checked attached files. I can say that I can do that as I'm quite familiar with KiCad and also Eagle. I can implement those changes u are after. In the meantime I w Plus
12 freelance font une offre moyenne de €182 pour ce travail
Hello there! Hope you doing good! If you still need this to be done, be sure to contact me. Lets make something awesome! Greetings!
Profile : ---------- over 14 years of experience in PCB layout design. Expertise in EDA layout tools Pads & Allegro. Over 6 years of experience in Ethernet related layout designs with Electrical interface, Op Plus
Hello. I have a experience for PCB(eagle,kicad,altium). I hope a cooperation with you. Regards. .................... ......................
Hi,sir. --------My motto is --------"Excellence and innovation built into every design." "Trust Me. I’m an Engineer.", "Good quality service on time, on demand."-------------- I am very interested in your job. I th Plus
I have a Master's Degree in Electrical Engineering and over 40 years of experience in electronics design, PCB design and specialized for most of my career in pulsed power, RF and high average power electronics and diag Plus