Fermé

Need help to solve the problem with DAC TLV561

PLEASE READ CAREFULLY: I DO NOT ASK BIDDER TO DESIGN, IMPLEMENT ANYTHING. I just want to ask if bidder had experience of the problem I have, and know how to fix my MY DESIGN. This is less than 1 HOUR OF WORK only if you.

I have my DAC design with TLV5613CPW. THe requirement of my system, I need to generate analog data at the rate of 2Msps. The purpose of my DAC is to generate a waveform as in the image attached here. The data I send to the DAC can be like this code below:

unsigned int data_dac;

while (1){

write_to_dac(data_dac++);

}

The schematic of my design in in a file here, the PCB layout file is also here, this is a 6 layer board with separate analog and digital GND. I also have copper pour on top and bottem of the board. The output from DAC are refernece to AGND only.

But there is the problemin my design: Each time I update the DAC value, there is an over/under shoot as in the image here. I capture the signal with very shoty ground "twezer probe", and the picture from the scope is when I have the DAC out pin lif up (pin down even worst). If you know why I have this problem and you know how I can fix this problem, please help.

I only want to get help from experience electrical engineer, with very strong Analog back ground, and you had done semilar design like mine. Will not accept any paid up front. And I will pay you in full if when your help really improve my design.

Bidder have to have Skype, ability to talk on Skype, Teamviewer

PLEASE READ CAREFULLY: I DO NOT ASK BIDDER TO DESIGN, IMPLEMENT ANYTHING. I just want to ask if bidder had experience of the problem I have, and know how to fix my MY DESIGN. This is less than 1 HOUR OF WORK only if you.

Compétences : Génie Électrique, Electronique

Voir plus : why you want to work here, why you want to be an engineer, why do you want to work here, why do you want to be an engineer, why do i want to work here, why do i want to be an engineer, top problem, problem problem, paid help, need engineering, need engineer help, need electrical engineering, i want to be an electrical engineering, i want to be an electrical engineer, i want to be a engineer, i need engineer to do, i need a electrical engineering, if you want to be an engineer, how to fix my, how to be a engineer, how do i get to work from here, help to fix, get help, engineer of electronics, electrical design work

Concernant l'employeur :
( 0 commentaires ) Escondido (San Diego), United States

N° du projet : #2343353

3 freelance ont fait une offre moyenne de 433 $ pour ce travail

beandigital

Please see Pm

500 $ USD en 1 jour
(1 Commentaire)
3.6
hardcorefs

please see the private message

400 $ USD en 1 jour
(0 Commentaires)
0.0
jsamgeorge

Hi, Please see Private message...

400 $ USD en 10 jours
(0 Commentaires)
0.0