I have a motherboard (Asus N61JA). I also have its schematic.
I do NOT have a case for this. This is purely motherboard only, with processor and memory (just enough for it to boot). This already turned on before, but I forgot how to do it.
I need someone to figure out how to turn this on without the power switch (i.e. what pins should I connect? What to use (jumper wire or resistor)?
Motherboard schematic is attached on this project. The switch is labelled "PWR_SW" on the schematic, and I think it's located on connector "J5601".
Milestone will be made AFTER the motherboard boots up. No, I'm not a scammer.