Aluminium Structural Support Design

I have an aluminium plate and tube design that I need manufacturing plans and engineering certification to be made. Requirements include: - Light load capacity (up to 50 kg) - No specific design standards or regulations Ideal skills and experience: - Proficiency in aluminium design - Experience with structural support frameworks - Knowledge of load-bearing calculations Design: - 10mm x 100mm x 500mm Main Base Plate - 50mm OD 1000mm tube with 3mm walls for a Main Tube - 50mm OD Tube with 3mm walls for a Brace Tube - Main Tube to connect at one end of the tube to the top of the Base Plate. - Brace tube to connect at one end of the tube to the bottom of the base plate and the other end of the tube to connect to the main tube 500mm from the free end. - 5 x 11mm holes to be drilled to fit a m10 bolt on the base plate - Free end of the Main tube to have a 10mm x 10mm flange -bolt holes will be used to have 3 (top and bottom and one of the 3 in the centre) pre-engineered Stage Truss Clamps which are rated for 300kg Each

Project ID: 40589557