Simple Arduino Project for Analogue NC NO switch demonstrations

Project to be delivered quickly. Do not bid blindly without reviewing the requirements and expect us to have a discussion later. Please ensure your timeline is realistic and you will stick to it. I am looking for a freelancer to create a simple Arduino project that demonstrates the use of an Analogue NC NO switch. Arduino Nano Project 3 1. On start up must be able to assess 6 separate analogue switches during a 10 second window. 2. During the 10 second window a piezo buzzer should sound (beeping on and off) so the user understands the Nano is assessing the switches 3. The Nano should be able to recognise whether the 6 switches have been set in a Normally Open or Normally closed state. This will change after every use. 4. If a NC or NO switch subsequently changes state the board should alarm for 15 seconds and then assess the condition of the switches again before returning to monitoring them. 5. Each Analogue Switch should have an LED associated with it. If the switch changes state (Example NO to NC) then the LED should illuminate at the same time as the buzzer sounding at requirement number 4. Notes: The buzzer will be a regular piezo buzzer. Deliverables: Coding for an Arduino Nano to support the functions detailed above. Pin diagram showing which pins will be used for the Analogue NC/NO switches, which will be used for the Piezo Buzzer and the layout for the LEDs Visual demonstration preferred via video.