I want code that will do the following;
1. Upon power up the Arduino will do no actions.
2. Upon button press (momentary button) spindle starts, stepper drops 10mm, stepper lifts 10mm and then spindle stops (10mm - 2 full rotations).
3. loop stops and awaits next button press.
Attached is a rough sketch of my setup.
I have an Arduino mega 2650 clone. See rough diagram attached.
Nema 23 stepper with 6 leads (using 4) driven by a 4A 9~40V Micro-Step CNC Single Axis TB6600 Stepper Motor Driver Controller.
Solid state relay switching a 240v AC 350W motor.
A Buck converter to power the arduino.
Hello Sir I am a Mechatronics engineer and I have a lot of experience dealing with these things. I have done similar tasks many times. I will definitely deliver your work on time and I will be pleased to do your projec Plus
9 freelance font une offre moyenne de £45 pour ce travail
For more details inbox me so that we can discuss in detail. For more details inbox me so that we can discuss in detail. For more details inbox me so that we can discuss in detail.
Hello, my name is Maria I am an electronic engineer with a lot of experiencie in arduino programming I would like to help you with your project. Let me know more info . Regards
Hello. I have rich experience about stepper motor control. I know that for TB6600 and arduino programming. I am interest like that. Regards.
I am an Electrical Engineer with a masters degree I have high proficiency in Electrical Engineering, HVAC, LTE system model, Thermal system design, FPGA, Verilog / VHDL, Matlab/ Simulink, Microcontroller, Modeling, op Plus
Hello! Nice to meet you! I have read your project carefully. I am very interested in your project. I am a Microelectronics and Automation engineering expert. I have a lot of experience on ARM, FPGA, DSP, Arduino, Raspb Plus
HI,I read your project description concerning Arduino and I'm Interested in knowing more about it . As an Electronics Engineer ,I have been working with robotics application for more than 3 years either for college pr Plus
Good day! I am interested in working on your project and I have hardware for testing. Please contact me so that we can discuss the details of your project. Look forward to your answer. Best regards.
Hi, I am Electrical and Electronics engineer. I have done many project based on Arduino. I will give you code written in Arduino IDE . you just confirm the Pin number at which you have connected the stepper motor.