I need a sketch for attiny85 using arduino code, to run 15 ws2812 leds.
Adafruit have a library for them here [url removed, login to view]
The pixels are on pin 3.
I have made software to send 45 8 bit values via serial @ 9600 to configure the colors.
The output looks like this->
The values are RGB, for each pixel one after another.
The values should be stored in eeprom and then written to the pixels.
Normally the sketch will read eeprom and set colors on startup, and wait for serial to update of required.
I attached the software if you wish to test.
Hi, I have neo pixel strip and ring. But I have Arduino board. But we can use the same source code for atttiny as these are from same family. But atttiny isn't having any hardware serial port and so we need to simulat Plus
4 freelance font une offre moyenne de $33 pour ce travail
Hello, Could you upload/send the software you are using to send the RGB values? Thank you in advance.
I am really good with arduino, If you give me the chance i'll help you out with your needs, I would like remote access to complete this task for you. I will not take payment till you're fully satisfied with the result.
ATtiny85 with USI communication receiving a string with the colors in sequence. write in eeprom and submit to digital output. ok. do you need a ok response to serial after execute de output to leds?