Write a modbus slave sketch to run on a Arduino Nano Every.
3 x 0utput - 0 to 6Khz (approximantely) clock outputs - modbus output registers base + 0-2
1 x Output - 1Khz (approximately) 10 bit PWM - modbus output register base + 3
5 x Bit ouput - Mapped from one register word - Base + 4
7 x Bit input - Bits mapped to one register word - Base + 5
3 x Bit input - Slave address (read on startup)
Pin assignments can be whatever you choose to suit clock outputs/timers.
10 freelances font une offre moyenne de 137 $ pour ce travail
Hello, thank you for your job posting. I read your description about--Arduino I am a senior electrical engineer. I have plenty of experience in firmware development and micro-controller developments. I can write the fi Plus
Hello, i can start work on it immediately. i have rich experiences in arduino and modbus protocal so much. i'm very much confident to reach your expectation and give you 100% satisfaction and quality work. hope you wi Plus
Hi, I am an firmware developer who are familiar with Arduino In the past I have implemented the temperature data collecting using RS485, Rs422 using arduino uno Also I have strong background in circuit design and c pr Plus
Hello sir/ma, I'm interested in taking this task up for you. i can show you my previous work done. I am an Electrical Engineer with a masters degree and I have high proficiency knowledge in: FPGA firmware in VHDL and Plus
Hello I am a mechanical engineer having over 4 years of experience of experience in micro-controllers, Arduino, and C++ programming. I have done various projects related to control systems, circuit analysis, Aurdino Plus
Hi i have a many experience with modbus. i can help you build modbus slave even without any library. let me know if you are interested
Hello, I am an Arduino expert, aware of the modbus protocol, and to start on your project right now. please contact me for more details. Regards,
Hello, I am Telecommunications and Electronics Engineer with deep knowledge in Arduino and microcontroller systems, I have one Arduino nano in my home. I can make your task by using an interactive simulation software c Plus
Dear Sir/Madam I have 3+years of experience in Software development, integration, and validation. I have completed more than 10 industrial projects. My skills are:- Programming- MATLAB, LabVIEW, Python, and C/C++, C# Plus
Hello, I have read your post carefully. I have rich experiences with arduino. And also I have a good knowledge of Modbus. My experiences will help you to be success. Thanks. Renat.