Plastic Astronaut helmet with visor with 3D printable file in STL format

  • État: Closed
  • Prix: $150
  • Propositions reçues: 23
  • Gagnant: makhan22

Résumé de concours

I'm needing to design a plastic Astronaut helmet with a spring loaded mirrored lens visor. It will need a small contained square over the mouth for a voice box to be inserted. The measurements on the voice box to come later.

The visor will cover the entire face, and held down by a latch, and pop open/up with springs so the face fully shows when latch is undone. Attached is a good starting point.

Compétences recommandées

Commentaire de l'employeur

“Amazing work, creative, and enjoyable to work with. Highly recommend!”

Image de profil adschiel, United States.

Tableau de clarification publique

  • adschiel
    Titulaire du concours
    • il y a 4 mois

    Hello all, and thank you all for your entries. A winner has been decided and has been notified. Thank you again.

    • il y a 4 mois
  • amirfreelancer12
    amirfreelancer12
    • il y a 4 mois

    HI , working on it , almost finish , please wait

    • il y a 4 mois
  • ahmadnazree
    ahmadnazree
    • il y a 4 mois

    Hi CH, please rate #22 . Thank you very much.

    • il y a 4 mois
  • prashant8080
    prashant8080
    • il y a 5 mois

    If I provide you the update, is there any chances you will respond ? or can guide with a corrections ?
    ( As I have prepared the Entire Model by using your picture as a reference, I feel that there is something still remaining, and that is what I am expecting from you if you can send me the feedback for the same ? )

    • il y a 5 mois
    1. adschiel
      Titulaire du concours
      • il y a 5 mois

      Yes, I will give feedback for every entry. Thank you for your interest.

      • il y a 5 mois
  • adschiel
    Titulaire du concours
    • il y a 5 mois

    Thanks for the interest. Size will be for an average size adult head... Not overly snug like a baseball helmet, but loose easy to get on and off... I would like to receive JPG photos displaying the helmet from all sides, and a 3D printable file in STL format.

    • il y a 5 mois
  • Vadymykh
    Vadymykh
    • il y a 5 mois

    Any information about 1) size 2) dimensions 3) end result? What do you expect to receive? .STL, .STP, .JPG?

    • il y a 5 mois

Montrer plus de commentaires

Comment commencez des concours

  • Publiez votre concours

    Publiez votre concours Rapide et facile

  • Obtenez des tonnes de propositions

    Obtenez des tonnes de propositions De partout dans le monde

  • Attribuez la meilleure proposition

    Attribuez la meilleure proposition Télécharger les fichiers - Facile !

Publier un concours maintenant ou rejoignez-nous maintenant !