Rubber-based Wristband Render 1
Hi CH, I'm no mechanical engineer, but I've been working with a larger magnitude in the past, please see my freelancer review. Please find the attached the enclosure for your PCB with the jack covered in PU. I've made this before I've read your update therefore the metal back plate. The screw an the LED placement are inline with the PCB. The electrode are tangent to wrist surface so that the could measure effectively. The are barrier preventing sweat or water from reaching the electrode. The styling are based on the Empathica, but if you want I can provide a better design. Please comment so that I could sent in a better one after this, with a polycarbonate and glass fiber back plate. Thank you very much.
Tableau de clarification publique
-
ahmadnazree
- il y a 6 ans
I've done my design but you have selected the winner, so I cannot post the entry. Good luck to your contest. I think you pick the correct winner. Smartrabbit has the experience to o job. Thank yoi very much.
- il y a 6 ans
-
ahmadnazree
- il y a 6 ans
'Alaikumsalam, I will send in another entry as soon as possible. Thank you so much.
- il y a 6 ans
-
Titulaire du concours - il y a 6 ans
Salam Ahmad, can you propose another model? something a lot less flashy, it is more a wristband than a watch. Check the link I have posted.
- il y a 6 ans
-
ahmadnazree
- il y a 6 ans
And ofcourse if this is selected, I will see it to the end, i.e. manufacturing like I did in other contest. Thank you very much.
- il y a 6 ans
